Cutting And Grinding Discs: Matching The Abrasive To The Job
Space and power supply are the other two practical constraints worth checking early. Confirming that a chosen machine will run comfortably from the electrical supply actually available in the workshop, and that there's room to work safely around it with materials laid out, avoids the common mistake of buying a machine that then can't be used the way it was intended.
Most domestic UK properties are supplied with single-phase power, typically 230V, which is more than adequate for light-duty inverter welders used for hobby work, repairs and general fabrication. Three-phase supply, commonly 400V to 415V across three live conductors, is standard in industrial premises and delivers power more efficiently to heavier equipment, which is why higher-output welders and plasma cutters, including some Fronius and ESAB machines, are often offered in a three-phase version.
Cutting capacity is usually described in terms of clean cut and maximum cut thickness, and the two are worth distinguishing. Clean cut is the thickness a machine handles with a good edge finish and reasonable speed, while maximum cut is the thickest material the machine will get through at all, usually slower and with a rougher edge. Buying with your typical material thickness in mind, rather than the thickest job you might occasionally face, generally gives a better day-to-day result.
Abrasive discs look interchangeable on a shelf but perform very differently depending on what they're made from and what they're used on. Cutting discs are generally thin, designed to slice through material quickly with minimal heat build-up, while grinding discs are thicker and shaped to remove material from a surface or clean up a weld, rather than cut all the way through it.
Our own TP Weld Tables range is designed and manufactured in-house in Yorkshire, cut on a fibre laser for tight tolerances, which is the kind of detail worth asking about wherever you're sourcing a table, and you can see the full range via tecproducts.co.uk.
Buying a first welder is easy to overthink. Rather than starting from a shortlist of machines, it helps to start from the work: what materials, what thickness, and how much of it will be done indoors versus outside or on-site. That single question narrows the choice between MIG, TIG and MMA far more usefully than comparing spec sheets in isolation, whether you end up looking at a Jasic entry-level MIG package or something further up the range.
